Imax B6 Charger Pc Software Manual Completely And

Please read this entire operating manual completely and attentively before using this product, as it covers a wide range of information on operating and safety.

Especially for Lithium batteries, it can prevent the overcharging which may lead to an explosion due to the users fault.

It can disconnect the circuit automatically and alarm once detecting any malfunction.

When the batterys voltage exceeds the threshold, the process will be terminated automatically.

Automatic charging current limit You can set up the upper limit of the charging current when charging your NiCd or NiMH battery; it is useful for the NiMH battery of low impedance and capacity in the AUTO charging mode.

WARNING: Failure to connect as shown in this diagram will damage this charger.

The main battery leads must be connected along with the balance lead connector as shown before charging your battery.

Never leave the charger unattended when it is connected to its power supply.

If any malfunction is found, TERMINATE THE PROCESS AT ONCE and refer to the operation manual.

Do not connect more than one battery pack to this charger at any one time.

Never attempt to charge or discharge the following types of batteries.

Especially, the Lithium battery should be charged according the charging instruction provided by the manufacturer strictly.

Attention should be paid to the connection of Lithium battery especially.

Do not attempt to disassemble the battery pack arbitrarily Please get highlighted that Lithium battery packs can be wired in parallel and in series.

Type Stop LiXX LiXX Discharge Storage Start Enter Program Select NiMH NiMH NiMH Charge NiMH Battery Discharge Cycle AutMan.

The screen displays the following information in sequence and the user can change the parameter on each screen.

If you need to alter the parameter value in the program, press StartEnter key to make it.

There are LiFe LiFe L i F e three kinds of Lithium battery: LiFe(3.3V), Lilo(3.6V) or LiPo(3.7V).

This V. T y p e 3.

V V.Type V.Type 3.3V.

If the screen displays temperature, you can use the optional temperature probe to connect to the surface of the battery.

If it is set as the USB port, you can connect the charger to your PC through the optional USB cable to monitor the charging process through optional software.

NiMH Sensitivity L i P o B A L A N C E The value on the left of the second line of the charger is current 2.

The value on the right side of the second lines sets the 2.